超声波清洗机的使用操作以及规程_
超声波清洗机的使用操作以及规程_济南洁升超声波清洗机
目 的：拟定B2200S型超声波清洁器的标准操作程序 范 围：适用于B2200S型超声波清洁器的操作 责任人：质检室全体人员 内 容：
1、运用过程：
目 的：拟定B2200S型超声波清洁器的标准操作程序 范 围：适用于B2200S型超声波清洁器的操作 责任人：质检室全体人员 内 容：
1.1、 在清洁器不带电的状况下，将清洁液参加清洁槽内。 1.2、将清洁器插头刺进相对应的电源。
1、运用过程：
1.3. Press the ON switch and allow the cleaner to degas for 2-3 minutes.
1.1、 在清洁器不带电的状况下，将清洁液参加清洁槽内。 1.2、将清洁器插头刺进相对应的电源。
1.4, according to the situation of dirt removal, usually clean 30 seconds ** 2 minutes, for items that are particularly difficult to clean, the cleaning time can be extended appropriately.
1.3、按下ON开关，答应清洁器作业2-3分钟除气。
1.5. Remove the cleaned items from the cleaning tank and rinse them under clear water. 1.6, dry and cleaned items, and oil as needed. 2, note · nbsp ^ fen ^
1.4、根据污垢去掉的状况，通常清洁30秒**2分钟，对于特别难清洁的物品，清洁时刻可适当延伸。
2.1, the cleaning machine should be used in an environment that is clean, boring and free of strong corrosive gases, and should prevent violent sensation. 2.2, the back of the generator should have a satisfactory cooling space.
1.5、将清洁过的物品从清洁槽中取出，放在清水下漂洗。 1.6、枯燥被清洁物品，并根据需要上油。 2、注意事项
2.3, to ensure that the machine has an excellent grounding to prevent personal injury. 2.4 When the cleaning machine is working, do not immerse your fingers in the cleaning solution.
2.1、清洁机应放在清洁、枯燥以及无强腐蚀气体的环境中运用，并应防止剧烈轰动。 2.2、发生器背面应留有满足的散热空间。
2.5. It is forbidden to start up under no-load condition. The change of the liquid level bump will cause the change of the output power to be large. When cleaning the object, it is longer than finding the good working liquid level, so that the output power of the cleaner is large, and the cleaning liquid does not support the cleaning liquid. Start work and the liquid level must not be less than half of the groove depth. 2.6. The object to be cleaned shall not touch the bottom of the tank, and it is recommended to put the workpiece into the tooling basket for cleaning.
2.3、保证机器有杰出的接地，以防止人身伤害事故。 2.4、清洁机作业时，不要将手指浸入清洁液中。
2.7. The cleaning liquid can be contacted with the seller. The cleaning liquid should not be strong acid or alkaline, and there is no reliable safety measure.2.5、禁止空载状态下开机。液位凹凸的改变会引起输出功率巨细的改变，清洁物件时，要长超声波清洗机价格于寻找**好的作业液位，使清洁器输出功率**大，在清洁槽内无清洁液的状况下，不答应开机作业，且液位不得低于槽深的一半。2.6、被清洁物不得和槽底触摸，主张将工件放入工装篮中清洁。
Under the conditions of application, solvents or flammable solutions that do not contain water cannot be used.
2.7、清洁液的选用可与销售商联系，清洁液不得呈强酸或强碱性，在没有可靠的安全措
2.8. Under normal conditions, the cleaner will heat up for 10-15 minutes, and the cleaning machine will work in succession **
施条件下，不能运用不含水的溶剂或易燃溶液。
Beyond 8 hours.
2.8、在正常状况下，清洁器接连作业10-15分钟会升温，清洁机接连作业时刻**好不要
2.9 If it is found that there is water leakage in the cleaning tank, it should be shut down and shut down, and the cleaning liquid should be emptied and contact the seller; 2.10, do not allow the private line to open the machine.
超越8小时。
2.11. When cleaning dexterous or valuable items, you should first test one item and then other
2.9、如发现清洁槽有漏水现象，应当即关机停用，并倒空清洁液后与销售商联系； 2.10、不答应私行拆开机器。
Items are cleaned.
2.11、当**次清洁精巧或贵重物品时，你应先将一件物品做一下试验，随后再将其他
2.12. If the cleaned items are mechanical parts, they must be cleaned one by one and oiled immediately after cleaning.
上一条:超声波清洗机的构造组成 下一条:超声波清洗机安全操作规程_洁升超声波清洗机 返回列表